Does engine need to be running to operate seadoo vts

Does engine need to be running to operate seadoo vts how to#
Does engine need to be running to operate seadoo vts full#

The unit may be purchased from outlets as like Partco,Europarts etc,but you may have to order it. To change the oil in your seedo with the least mess you ought to buy a vacuum unit made especially to evacuate the oil.This unit can also be used on your motor vehicles.car van etc if you have any questions, email me.How do I change to pump oil in my 1999 SeaDoo XP? reassemble the rest (using the blue loctite on all the bolts. be careful not to put the plug in crooked or overtighten. put pipe thread sealer on fill plug (not teflon tape).

Does engine need to be running to operate seadoo vts full#

you may think it's full but stop for a minute and then see if it takes more. fill the pump it should hold about 2 1/2 to 3 oz. remove the fill plug, it should be pressure tested 9 p.s.i. push the cone straight in and tighten the screws while holding the cone in. use blue loctite on the screws ant start all three. apply loctite 518 to rhe o-ring andput it on the cone. get a new o-ring from the dealer when you get your pump oil p/n 293300011.if they try to sell you a 293250085, the 011 fits better. if it is half moon shaped pay close attentoin to the taper on the back side to match the tapre of the spring and retainer.clean all the old sealer off the o-ring surface of the cone. the white thing inside is called a pusher if it is round dont worry about it, it shouldnt fall out. there is water in it and it will need to be resealed. be sure not to turn engine over or pull on impeller shaft while you have cone off!!! if it has not been changed in a while it will be black and stinky. put the pan under the pump and using a plastic handle of a big screwdriver tap on the point until it comes off. (make a catch pan out of a plastic jug, cut about 1' from bottom.) raise the front of the trailer as high as you can get it. remove the three 5mm allen screws that hold on the pump cone.

then remove the four 13mm bolts that hold the venturi and steering nozzle on. disconnect the steering cable and the vts rod from the steering nozzle.

Sorry but don has no idea what he is talking about.

Does engine need to be running to operate seadoo vts how to#

Does anybody know how to change the pump oil in a 1999 SeaDoo XP jet ski? Thanks!How do I change to pump oil in my 1999 SeaDoo XP?